Page 1 of 1

Re: MS45.1 SAP delete.

Posted: Thu Jun 18, 2020 10:13 pm
by stanghp
Does anyone know the data parameters for the SAP to have the readiness monitor "complete" to pass emissions??

Re: MS45.1 SAP delete.

Posted: Wed Dec 29, 2021 12:15 pm
by kellyian0414
If all the other monitors are complete then you should be fine with just the one incomplete for the SAP. But if you happen to find the solution let me know, i've been trying to figure out how to turn my SAP monitor off so it reads not available too haha

Re: MS45.1 SAP delete.

Posted: Wed Apr 27, 2022 2:01 pm
by rkneeshaw
I dont have emissions checks so I dont know if this will work for you.

One one hand, you can remove the SAP and then reset learned variants so the car doesnt even think it has a SAP module at all.

If that doesnt work for you, you can try changing c_obd_state_2 to 101 (109 is stock). 101 will show SAP tests are supported in OBD2 checks.